Edge-Core WA6202AM EU Uživatelská příručka stáhnout pdf (Strana 141)

Radio Interface

6-87

The configuration settings for WPA are summarized below:

CLI Commands for WPA Using Pre-shared Key Security – From the VAP interface

configuration mode, use the auth wpa-psk required command to enable WPA

Pre-shared Key security. To enter a key value, use the wpa-pre-shared-key

command to specify a hexadecimal or alphanumeric key. To view the current

security settings, use the show interface wireless a [0-3] or show interface

wireless g [0-3] command (not shown in example).

Table 6-4. WPA Configuration Settings

WPA and WPA2 pre-shared key only WPA and WPA2 over 802.1X

Encryption: Enabled

Authentication Setup: WPA-PSK, WPA2-PSK, or

WPA-WPA2-mixed

Cipher Suite: WEP/TKIP/AES-CCMP

WPA Pre-shared Key Type: Hex/ASCII

Encryption: Enabled

Authentication Setup: WPA, WPA2,

WPA-WPA2-mixed

Cipher Suite: WEP/TKIP/AES-CCMP

(requires RADIUS server to be specified)

1: You must enable data encryption in order to enable all types of encryption in the access point.

2: Select TKIP when any WPA clients do not support AES. Select AES only if all clients support AES.

Enterprise AP(config)#interface wireless g 7-88

Enter Wireless configuration commands, one per line.

Enterprise AP(if-wireless g)#vap 0

Enterprise AP(if-wireless g: VAP[0])#wpa-pre-shared-key

passphrase-key agoodsecret

7-126

Enterprise AP(if-wireless g: VAP[0])#auth wpa-psk required

Data Encryption is set to Enabled.

WPA2 Clients Mode is set to Disabled.

WPA Clients Mode is set to Required.

WPA Multicast Cipher is set to TKIP.

WPA Unicast Cipher can accept TKIP only.

WPA Authentication is set to Pre-Shared Key.

Enterprise AP(if-wireless g: VAP[0])#

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 331 332

Žádné komentáře

Edge-Core WA6202AM EU Uživatelská příručka Strana 141