Edge-Core WA6202AM EU Uživatelská příručka stáhnout pdf (Strana 185)

System Clock Commands

7-33

show event-log

This command displays log messages stored in the access point’s memory.

Syntax

show event-log

Command Mode

Exec

Example

System Clock Commands

These commands are used to configure SNTP and system clock settings on the

access point.

Enterprise AP#show event-log

Mar 09 11:57:55 Information: 802.11g:11g Radio Interface Enabled

Mar 09 11:57:55 Information: 802.11g:Radio channel updated to 8

Mar 09 11:57:34 Information: 802.11g:11g Radio Interface Enabled

Mar 09 11:57:18 Information: 802.11g:11g Radio Interface Enabled

Mar 09 11:56:35 Information: 802.11a:11a Radio Interface Enabled

Mar 09 11:55:52 Information: SSH task: Set SSH server port to 22

Mar 09 11:55:52 Information: SSH task: Enable SSH server.

Mar 09 11:55:52 Information: Enable Telnet.

Mar 09 11:55:40 Information: 802.11a:11a Radio Interface Disabled

Mar 09 11:55:40 Information: 802.11a:Transmit Power set to QUARTER

Press <n> next. <p> previous. <a> abort. <y> continue to end :

Enterprise AP#configure

Enter configuration commands, one per line. End with CTRL/Z

Enterprise AP(config)#logging clear

Table 7-7. System Clock Commands

Command Function Mode Page

sntp-server ip Specifies one or more time servers GC 7-34

sntp-server enable Accepts time from the specified time servers GC 7-34

sntp-server date-time Manually sets the system date and time GC 7-35

sntp-server

daylight-saving

Sets the start and end dates for daylight savings time GC 7-36

sntp-server timezone Sets the time zone for the access point’s internal clock GC 7-36

show sntp Shows current SNTP configuration settings Exec 7-37

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 331 332

Žádné komentáře

Edge-Core WA6202AM EU Uživatelská příručka Strana 185